Amana-Goodman 0154F00004S Vent Motor Gasket

The Amana-Goodman 0154F00004S Vent Motor Gasket is an OEM replacement gasket for the ventor motor (draft inducer) assembly on compatible Goodman and Amana gas furnaces. The ventor motor pulls combustion gases through the heat exchanger and pushes them out the vent, so the joint where the inducer housing meets the collector box sits directly in the exhaust path. This gasket seals that mating surface so flue gas and moisture stay inside the system and the pressure switch sees a true draft reading.

The 0154F00004S is listed for multiple Goodman and Amana furnace applications, including select VMS, GMES, GMS and AMVC series equipment. Parts catalogs use ventor motor, vent motor and inducer motor interchangeably, so the same gasket may be listed under any of those names. Related Goodman gaskets such as 0154F00003 and B1392633 are catalogued as 14-inch vent motor gaskets, and 0154F00001P is a draft inducer gasket kit. Each of these is a separate part number, so compare the original gasket and confirm the number on the old part before substituting. Always verify the complete furnace model number, serial number and existing part number before ordering.

A hardened, cracked or flattened gasket usually shows up as soot or rust streaks at the joint, a flue gas odor, moisture around the collector box, or a pressure switch that drops out because the inducer cannot hold a steady draft. Whenever the ventor assembly is unbolted for motor replacement, cleaning or heat exchanger inspection, replace the gasket, because a used gasket rarely reseals. Clean both sealing surfaces of old gasket material and rust, seat the new gasket without stretching it, and tighten the mounting screws evenly in a cross pattern. After reassembly, run a full heat cycle and check the joint for leaks. Work on the combustion and venting system belongs with a qualified HVAC technician.

Key Benefits

• OEM Fit: genuine Amana-Goodman part number 0154F00004S for compatible ventor/inducer motor assemblies.
• Sealed Exhaust Path: restores the sealing surface between the inducer housing and collector box, keeping flue gas inside the vent system.
• Stable Draft: a tight joint supports a consistent draft signal for the pressure switch during startup and operation.
• Service Ready: listed for select VMS, GMES, GMS and AMVC series Goodman and Amana furnaces where this exact number is specified.

Common Questions

• Is a ventor motor gasket the same as an inducer motor gasket? Yes in practice. Ventor is Goodman's name for the draft inducer, so the 0154F00004S is used in the ventor/inducer motor assembly on compatible furnaces.
• Which furnaces use the 0154F00004S gasket? It is listed for select VMS, GMES, GMS and AMVC series models. Confirm with the full furnace model and serial number, and compare against 0154F00003 or B1392633 only as separate part numbers, never as automatic equivalents.
• Should the gasket be replaced when servicing the ventor assembly? Yes. Inspect the sealing surfaces whenever the assembly comes off, and replace a compressed, brittle or torn gasket so the collector box joint stays gas-tight.

This item is not eligible for free shipping.

Disclaimer: While we strive for 100% accuracy, product data and specifications are subject to change. Please contact our team to confirm compatibility or technical details before purchasing.